Our range of sewing threads for underwear slips prevent seam puckering and offer good seam strength as well as elongation.
Approximate thread consumption for a full length underslip is 75 meters. A half length waist slip has an approximate thread consumption of 40 meters. Depending on the required final quality, alternative thread types may be used. Thread size will determine needle size.
For more information, check out our recommendations below.
Take the next step
Contact one of our experts to find out more information.
Where two Tex sizes of thread have been suggested the choice will be determined by:
- The demands of the stitching operation
- The amount of load / demand placed on the seam
- The stitch definition required (topstitching)
Coverseaming on underslips may involve the following stitch types:
- 406 - Twin needle coverseam
- 407 - Three needle coverseam
- 605 - Three needle coverseam with a top covering thread
The recommendations in the table above apply to all of these stitch types. The choice of which thread to use for top cover is determined by the appearance required.
In almost all cases the product selected for top covering thread, on underslips, is the same substrate as the thread used in the other elements of the stitch type, in this case Epic.
However if a specific stitch appearance is required then other threads may be used for top covering. Popular top covering threads include:
Gramax, Epic and Sylko.
The sewing thread recommendations laid out above are intended as a guide to aid the construction of garments with good quality seams. As garments of the same generic type differ in terms of fabric substrate and construction, and both making up methods and post make up processing can greatly vary, these recommendations should be viewed as a good starting point for thread selection.
Garment specific recommendations for thread and needle selection as well as accurate thread consumption figures and on-site technical support can be obtained by contacting your local Coats' office.
These recommendations and consumption figures are intended as a guide only and are given in good faith but without warranty or liability on the company or its employees.